Chamber Mates Sub Gauge Shotgun Chamber Inserts Directions For Use

		Grease the O-Ring located at the forward end of the tubes before attempting to insert the Chamber MatesÔ into the chamber of your gun.
	Gently slide the Chamber MatesÔ into the chamber of your gun making sure that you position them whereby the extractors are in alignment with the extractors of your gun. Once they are aligned, push the Chamber MatesÔ fully into the chamber.
		To remove, stick the supplied removal tool thru the breech end of the insert tube, hook it over the front edge of the tube and pull it out.

	In the event that a tube becomes difficult to remove using the removal tool, a cleaning rod or a 1/2" dowel rod with a fired 28 gauge hull over the end of it can be used to bump them out from the muzzle end.
	WARNING! * For use in Break Open Shotguns only. Do not attempt to use in autos, pumps or bolt actions. * Thoroughly clean your chamber and barrel after each use. * Do not attempt to use in shotguns other than the gauge they are designed for. * Do not attempt to use shells of a gauge other than the conversion gauge. * Do not attempt to load a live shell until the insert tube is fully seated in the chamber of the gun. * For use with lead or bismuth shot only. Do not attempt to use steel or tungsten shot. * Do not attempt to use in Damascus twist barrels.